RESUMO
High quality carbonate chemistry measurements are required in order to fully understand the dynamics of the oceanic carbonate system. Seawater pH data with good spatial and temporal coverage are particularly critical to apprehend ocean acidification phenomena and their consequences. There is a growing need for autonomous in situ instruments that measure pH on remote platforms. Our aim is to develop an accurate and precise autonomous in situ pH sensor for long term deployment on remote platforms. The widely used spectrophotometric pH technique is capable of the required high-quality measurements. We report a key step towards the miniaturization of a colorimetric pH sensor with the successful implementation of a simple microfluidic design with low reagent consumption. The system is particularly adapted to shipboard deployment: high quality data was obtained over a period of more than a month during a shipboard deployment in northwest European shelf waters, and less than 30 mL of indicator was consumed. The system featured a short term precision of 0.001 pH (n=20) and an accuracy within the range of a certified Tris buffer (0.004 pH). The quality of the pH system measurements have been checked using various approaches: measurements of certified Tris buffer, measurement of certified seawater for DIC and TA, comparison of measured pH against calculated pH from pCO2, DIC and TA during the cruise in northwest European shelf waters. All showed that our measurements were of high quality. The measurements were made close to in situ temperature (+0.2°C) in a sampling chamber which had a continuous flow of the ship's underway seawater supply. The optical set up was robust and relatively small due to the use of an USB mini-spectrometer, a custom made polymeric flow cell and an LED light source. The use of a three wavelength LED with detection that integrated power across the whole of each LED output spectrum indicated that low wavelength resolution detectors can be used instead of the current USB mini spectrophotometer. Artefacts due to the polychromatic light source and inhomogeneity in the absorption cell are shown to have a negligible impact on the data quality. The next step in the miniaturization of the sensor will be the incorporation of a photodiode as detector to replace the spectrophotometer.
RESUMO
Aberrant glutamatergic neurotransmission may underlie the pathogenesis of schizophrenia and metabotropic glutamate receptors (mGluRs) have been implicated in the disease. We have established the localization of the group III mGluR subtype, mGluR8, in the human body and investigated the biological effects of the selective mGluR8 agonist (S)-3,4-dicarboxyphenylglycine ((S)-3,4-DCPG) in schizophrenia-related animal models. The mGlu8 receptor has a widespread CNS distribution with expression observed in key brain regions associated with schizophrenia pathogenesis including the hippocampus. (S)-3,4-DCPG inhibited synaptic transmission and increased paired-pulse facilitation in rat hippocampal slices supporting the role of mGluR8 as a presynaptic autoreceptor. Using the rat Maximal Electroshock Seizure Threshold (MEST) test, (S)-3,4-DCPG (30 mg/kg, i.p.) reduced seizure activity confirming the compound to be centrally active following systemic administration. (S)-3,4-DCPG did not reverse (locomotor) hyperactivity induced by acute administration of phenylcyclidine (PCP, 1-32 mg/kg, i.p.) or amphetamine (3-30 mg/kg, i.p.) in Sprague-Dawley rats. However, 10 nmol (i.c.v.) (S)-3.4-DCPG did reverse amphetamine-induced hyperactivity in mice although it also inhibited spontaneous locomotor activity at this dose. In addition, mGluR8 null mutant mouse behavioral phenotyping revealed an anxiety-related phenotype but no deficit in sensorimotor gating. These data provide a potential role for mGluR8 in anxiety and suggest that mGluR8 may not be a therapeutic target for schizophrenia.
